Home Projects

Turn off water supply, Remove old sink, Clean sink area, Install faucet on new sink, Attach drain assembly, Apply plumber’s putty, Position sink in place, Secure sink to vanity, Connect water supply lines, Install P-trap, Turn on water supply, Check for leaks, Seal edges with caulk

Clean the tile surface, Mix the grout, Apply grout with a float, Work grout into joints, Remove excess grout, Wipe tiles with damp sponge, Let grout cure, Buff haze off tiles, Apply grout sealer, Clean up tools

Clean tile surface, Mix the grout, Apply grout with float, Press grout into joints, Remove excess grout, Wipe tiles with damp sponge, Buff haze with dry cloth, Let grout cure, Apply grout sealer, Clean up tools

Measure the floor area, Clean and prep the subfloor, Install backer board if needed, Plan tile layout with chalk lines, Mix thin-set mortar, Spread mortar with notched trowel, Lay tiles with spacers, Cut tiles to fit edges, Let mortar cure, Remove spacers, Mix and apply grout, Wipe excess grout with

Wear safety gear, Remove broken glass, Clean window frame, Measure window opening, Buy replacement glass, Test fit the glass, Apply glazing putty, Insert new glass, Secure with glazing points, Apply more putty, Smooth and shape putty, Let putty cure, Paint or seal edges

Measure the existing door, Remove the old door, Remove the old door frame, Prepare the rough opening, Dry fit the new door, Apply caulk to the sill, Insert the new door, Level and shim the door, Secure the door with screws, Check door operation, Seal around the frame, Install trim

Turn off power to the disposal, Check for a reset button under the unit, Press the reset button, Inspect for jams inside the disposal, Use a hex key to manually turn the motor, Remove any visible obstructions, Restore power and test the unit, Check the circuit breaker if still not

Place a bucket under the P trap, Turn off the faucet, Loosen the slip nuts on the P trap, Remove the P trap, Inspect washers and gaskets, Replace damaged parts, Wrap threads with plumber’s tape, Reinstall the P trap, Tighten the slip nuts, Turn on the faucet, Check for leaks,

Measure the floor area, Clean and prep the subfloor, Install backer board if needed, Plan tile layout with dry fit, Mark center lines with chalk, Mix thin-set mortar, Spread mortar with notched trowel, Lay tiles with spacers, Cut tiles to fit edges, Let mortar cure, Mix and apply grout, Wipe