Clean the surface with a microfiber cloth to remove dirt, grease, and dust.
Dry the surface completely before applying the decal.
Position the decal on the surface and secure it with masking tape as a hinge.
Lift one side of the decal and peel off the backing paper halfway.
Spray application fluid on the exposed adhesive side and the surface.
Carefully lay the decal onto the surface starting from the center outward.
Use a squeegee or plastic card to press the decal down, working from center to edges.
Peel off the remaining backing paper while spraying application fluid as needed.
Continue applying the decal with the squeegee to remove bubbles and fluid.
Once fully applied, slowly peel off the transfer tape at a sharp angle.
Check for any small bubbles and gently press them out with the squeegee.
Use a pin to pop stubborn bubbles and smooth them out carefully.
Trim any excess vinyl with scissors or a utility knife if necessary.
Avoid stretching the decal during application to prevent distortion.
Let the decal sit undisturbed for at least 24 hours to cure properly.
Do not wash or wax the area for at least 48 hours after application.
Work in a shaded, dust-free area to prevent premature drying or contamination.
Wear gloves if needed to avoid fingerprints on the adhesive side.
Ensure the temperature is between 50°F and 90°F for best adhesion.
Recheck the edges after curing and press down any lifted corners.
