Car Repair

Install drop-in bed liner, Replace interior dome light with LED, Install tailgate assist, Mount phone holder, Place all-weather floor mats

Clean the surface thoroughly, Position the decal using masking tape, Peel backing from one side of the decal, Spray application fluid on surface and decal, Apply the decal starting from one edge, Use squeegee to press out air and fluid, Peel off transfer tape slowly, Smooth out any remaining bubbles,

Inspect the bolts and mounting points, Clean the bolt threads, Apply threadlocker to bolt threads, Install lock washers or lock nuts, Reinstall the bolts, Torque bolts to specification, Let threadlocker cure fully

Wash and dry the truck, Mix vinegar and water in spray bottle, Spray solution on affected areas, Wipe with microfiber towel, Apply water spot remover if needed, Buff with clean microfiber towel, Clean glass with automotive glass cleaner, Polish paint if spots persist, Apply wax or sealant to protect surface

Wash the plastic trim, Dry the trim thoroughly, Clean with isopropyl alcohol, Apply trim restorer with applicator pad, Let the product sit as directed, Buff off excess with microfiber cloth, Repeat if needed for deeper restoration, Allow trim to cure before driving

Clean the drilled hole area, Apply rust inhibitor to bare metal, Let rust inhibitor dry, Apply touch-up paint if desired, Let paint dry completely, Load sealant into caulking gun, Apply sealant around hole edges, Smooth sealant with gloved finger, Wipe excess sealant, Let sealant cure per instructions

Plan accessory placement, Mark hole locations, Drill pilot holes, Drill to rivnut size, Deburr holes, Insert rivnut into tool, Install rivnut into hole, Compress rivnut with tool, Remove tool, Repeat for all holes, Apply rust inhibitor, Mount accessory with bolts

Disconnect the negative battery terminal, Inspect accessory wiring for issues, Check for proper grounding, Use a multimeter to test for parasitic draw, Pull fuses one by one to isolate the draw, Install relays for high-draw accessories, Add inline fuses to all accessory circuits, Connect accessories to ignition-switched power, Secure all

Check the light switch, Inspect the fuse, Test the wiring with a multimeter, Check the ground connection, Inspect the light bulbs or LEDs, Replace faulty components, Reconnect and secure all wiring, Test the lights again