Remove the screws holding the cabinet hinge using a screwdriver.
Take off the hinge to expose the stripped screw hole in the wood.
Clean out any loose debris or splinters from the stripped hole.
Apply a small amount of wood glue to several wooden toothpicks or a dowel.
Insert the glue-covered toothpicks or dowel tightly into the stripped hole.
Tap the toothpicks or dowel gently with a hammer until snug in the hole.
Wipe away any excess glue from around the hole using a damp cloth.
Clamp the area if needed and allow the glue to dry fully, typically a few hours.
Once dry, use a utility knife to trim the toothpicks or dowel flush with the surface.
Lightly sand the area if needed to ensure a smooth surface for the hinge.
Use a drill to create a small pilot hole in the repaired area.
Align the cabinet hinge back into its original position.
Insert the screws into the pilot holes and tighten them securely.
Ensure the hinge is firmly attached and the door opens and closes smoothly.
Replace screws with slightly longer ones if extra grip is needed.
Avoid overtightening screws to prevent re-stripping the hole.
Test the cabinet door for proper alignment and adjust if necessary.
Clean up any remaining glue or debris from the repair area.
