Put on rubber gloves to protect your hands from germs and dirty water.
Place old towels or rags around the toilet base to catch any spills or splashes.
Pour a generous amount of dish soap into the toilet bowl to help lubricate the clog.
Heat water until hot but not boiling, then carefully pour it into the toilet bowl.
Allow the hot water and soap to sit for 5–10 minutes to soften the clog.
Position the plunger over the drain hole, ensuring a tight seal is formed.
Plunge up and down vigorously for about 20 seconds to create pressure and dislodge the clog.
Lift the plunger and check if the water drains; if not, repeat the plunging process.
If plunging fails, retrieve a toilet auger and insert it slowly into the drain.
Rotate the auger handle clockwise to break through or hook the clog.
Continue feeding and rotating the auger until resistance decreases or the clog is cleared.
Slowly retract the auger, being careful not to splash or damage the bowl.
Flush the toilet to check if the clog is fully cleared and water flows normally.
Repeat augering and flushing if the clog remains partially blocked.
Dispose of any waste caught on the auger in a trash bag and rinse the tool thoroughly.
Clean the toilet bowl and surrounding area with disinfectant to remove any residue.
Wash your gloves and hands thoroughly with soap and water after completing the task.
If the toilet remains clogged after multiple attempts, consider calling a plumber.
Store tools in a clean, dry place for future use.
Ventilate the bathroom to remove any odors caused by the clog.
